Configuring dynamic local peer IP on a PPPoE interface

Last Updated : Nov 06, 2012 |
Prolog information
Metadata
Keywords:
  1. Enter the context of the FastEthernet interface.
    For example:
    Gxxx-001(config)# interface fastethernet 10/3
    Gxxx-001(config-if:FastEthernet 10/3)#
  2. Enter the following commands in the context of the interface: no ip address, encapsulation pppoe, and ip address negotiated.
    Gxxx-001(config-if:FastEthernet 10/3)# no ip address
    Done!
    Gxxx-001(config-if:FastEthernet 10/3)# encapsulation pppoe
    Done!
    Gxxx-001(config-if:FastEthernet 10/3)# ip address negotiated
    Done!
  3. Exit the context of the interface, and set the interface name as the next hop.
    For example:
    Gxxx-001(config-if:FastEthernet 10/3)# exit
    Gxxx-001(config)# ip default-gateway FastEthernet 10/3
    Done!
    ADDITIONAL INFORMATION:
    Note:
    PPP over Ethernet (PPPoE) is a client-server protocol used for carrying PPP-encapsulated data over Ethernet frames. You can configure PPPoE on the Branch Gateway’s ETH WAN Fast Ethernet port. For more information about PPPoE on the Branch Gateway, see Configuring PPPoE.
Related links
Dynamic local peer IP