Adjusting the neon voltage

Last Updated : Apr 29, 2014 |
Prolog information
The neon voltage must be adjusted under these conditions:
  • Ringing option is set to 25 Hz. Maximum neon voltage is 120 Volts.
  • Neon message waiting lamps are present on telephones.
Use this procedure to adjust the neon voltage.
  1. Call a telephone with a neon message indicator and leave a message.
  2. Check for ring ping (single ring pulse) each time the lamp flashes (approximately every 3 seconds).
  3. Adjust the neon voltage control clockwise in small increments until the ring ping stops.
    ADDITIONAL INFORMATION:
    See the figure. Ensure that the message lamp still lights when the adjustment is finished.
  4. Type logoff and press Enter to logoff the system and to prevent unauthorized changes to data.
  5. Set the left and right doors onto the hinge pins and close the doors.
    ADDITIONAL INFORMATION:
    The doors must be closed to prevent EMI emissions. Tighten the door screws.
  6. Set the cover panel onto the right panel and secure.