After triggering a test failover, verify that the previously active Routing Core Server is in alternate mode. You must also check that one of the previously alternate Routing Core Server instances is active and hosts the VIP address.
Before you begin
Trigger a failover.
Procedure
On Configuration Server, start the SSH session.
To access Routing Core Server, run the following command:
ssh mega@<server_IP_address>, where <server_IP_address> is the static IP address of the Routing Core Server.
In the command prompt, run the following command:
hostname -I
Verify the server IP addresses in the command output.
When you run the hostname -I command on the previously active server, the command output does not display the VIP address. The command output displays the VIP address for one of the previously alternate Routing Core Server instances.
