Configuring Avaya Aura Session Border Controller networks

Last Updated : Dec 07, 2020 |

About this task

Use this procedure to configure Avaya Aura® Session Border Controller.

This procedure is required only for the remote worker agent configuration.

Procedure

  1. Log on to the EMS web interface with administrator credentials.
  2. In the navigation pane, click Device Specific Settings > Network Management > Interfaces.
  3. On the Interfaces page, enable the following interfaces:

    • A1 internal interface

    • B1 external interface

  4. On the Networks tab, configure the following networks:

    • A1 internal network

    • B1 external network

  5. For external web and mobile access, assign three IP addresses to each network as follows:

    Three external IP addresses:

    • One IP address for the Avaya Aura® Web Gateway reverse proxy

    • One IP address for the AvayaMobileCommunications reverse proxy

    • One IP address for the TURN relay service

    Three internal IP addresses:

    • One IP address for the Avaya Aura® Web Gateway reverse proxy

    • One IP address for the AvayaMobileCommunications reverse proxy

    • One IP address for the TURN relay service