Editing the NIC configuration

Last Updated : Nov 19, 2026 |
Prolog information
Network interfaces are configured during the AE Services installation process on the Configure Network Information page.
Use this procedure only if you need to change the NICsettings from Auto-Negotiate to Lockdown (100M links only).
The values that are initiallydisplayed on the Network Configurepage reflect the negotiated valuesbetween the NICs on the AE Services server and the Ethernet switch on your network.
Important:
AE Services has been tested at 1000BaseT full duplex and 100BaseT full duplex. Theseare the required speed and duplex mode settings for both network interfaces eth0 and eth1.
  1. On the AE Services Management Console, click Networking Network Configure.
  2. On the Network Configure page, edit any of the settings that you want to change, and click Apply Changes.
    ADDITIONAL INFORMATION:
    Note:
    Changing the settings for a NIC will cause the NIC to restart. Once you change the settings, they remain in effect until you reset them. Rebooting the AE Services server will not reset any of the values.