Configure global settings to set up the OSD menu language, video output type and quality, and Tally mode. You can also enable Auto Patrol so that the camera goes through the preset PTZ positions in a cycle.
On the main menu, select Setup.
On the Setup menu, for the Language setting, select the OSD menu language.
STEP RESULT:
The OSD menu language changes automatically.
For the DVI Mode setting, select one of the following DVI connector output types:
HDMI
DVI
For the Video Format setting, select the output video format.
For the Auto Patrol setting, select one of the following options:
On: To enable Auto Patrol.
Off: To disable Auto Patrol.
ADDITIONAL INFORMATION:
If you enable Auto Patrol, the camera starts continuously going through all preset PTZ positions and stays in them for the set time. The cycle continues until you disable the setting.
If you enabled Auto Patrol, for the Residence Time setting, select the number of seconds during which the camera stays in each preset PTZ position when auto patrolling the scene.
If you enabled Auto Patrol, for the Call Preset Speed setting, select the speed at which the camera goes from one preset position to another.
Select Video Mode.
On the Video Mode menu, for the SDI-3G Mode setting, select the type of the 3G-SDI output interface.
ADDITIONAL INFORMATION:
Level A supports one 3G stream. Level B supports two 1.5G streams: one dual-link stream or two separate streams.
For the Video Output setting, select one of the following options:
HDMI
SDI
Select Back to return to the Setup menu.
Select Other.
For the Auto Inversion setting, select one of the following options:
On: To invert the video image vertically.
Off: To display the original video image.
For the Tally Mode setting, select one of the following options:
On: To enable Tally mode.
Off: To disable Tally mode.
ADDITIONAL INFORMATION:
Tally mode enables additional VISCA commands to manage the Tally light.
For the Pre Attr setting, select one of the following options:
