Configuring the simple VPN topology

Last Updated : Nov 06, 2012 |
Prolog information
  1. Configure each branch as follows:
    • The default gateway is the Internet interface
    • VPN policy is configured on the Internet interface egress as follows:
      • Traffic from the local subnets to any IP address is encrypted, using tunnel mode IPSec
      • The remote peer is the Main Office (the VPN Hub)
    • An access control list (ACL) is configured on the Internet interface to allow only the VPN / ICMP traffic. See Simple VPN topology for configuration settings.
  2. Configure the VPN Hub (Main Office) as follows:
    • Static routing: Branch subnets > Internet interface
    • The VPN policy portion for the branch is configured as a mirror image of the branch, as follows:
      • Traffic from any to branch local subnets > encrypt, using tunnel mode IPSec
      • The remote peer is the VPN spoke (Branch Internet address)
    ADDITIONAL INFORMATION:
    Note:
    For information about using access control lists, see Policy lists.