Configuring the edge Branch Session Manager system in text mode through CLI

Last Updated : Aug 09, 2023 |
Prolog information
Metadata
Keywords:
Before you begin
  • Deploy and configure System Manager.
  • Deploy the edge Branch Session Manager server.
  1. Log in to the edge Branch Session Manager command-line interface.
  2. Type the following command:
    ADDITIONAL INFORMATION:
    edgeSetup -t
    STEP RESULT:
    Edge Branch Session Manager displays the Edge Configuration page.
  3. In ADC FQDN, type the FQDN of the application delivery controller.
  4. In ADC Port, type the port of the application delivery controller.
    ADDITIONAL INFORMATION:
    The default port is 443.
  5. In Primary System Manager FQDN, type the FQDN of the primary System Manager server.
  6. At the Is this part of a Geo-Redundant system prompt, type one of the following:
    • y if edge Branch Session Manager is part of the System Manager Geographic Redundancy system.
      When you type y, edge Branch Session Manager displays the Secondary System Manager FQDN field.
    • n if edge Branch Session Manager is not part of the System Manager Geographic Redundancy system.
  7. In Secondary System Manager FQDN, type the FQDN of the secondary System Manager server for the System Manager Geographic Redundancy system.
  8. In Virtual FQDN, type the virtual FQDN of the System Manager server.
  9. In Enrollment Password, type the enrollment password.
    ADDITIONAL INFORMATION:
    Enrollment password must match with the value on the SecurityCertificatesEnrollment Password page.
  10. In Enrollment Password (again), retype the enrollment password and press Enter.
    STEP RESULT:
    Edge Branch Session Manager applies the changes and starts the trust management with System Manager.