For a full description of the commands and their output fields, see Avaya Branch Gateway G450 CLI Reference.
|
Root level command
|
Command
|
Description
|
|
clear controller counters
|
-
|
Reset the controller counters
|
|
controller
|
-
|
Enter configuration mode for a specific controller
|
|
-
|
cablelength long (T1)
|
Set transmit and receive levels for a cable longer than 655 feet
|
|
-
|
cablelength short (T1)
|
Set transmit levels for a cable of length 655 feet or shorter
|
|
-
|
channel-group
|
Create a channel group logical interface for a PPP or Frame Relay session
|
|
-
|
clock source
|
Set the clock source for an E1 or T1 controller
|
|
-
|
fdl
|
Define the type of Facility Data Link loopback that the remote line is requested to enter
|
|
-
|
framing
|
Set the frame type for an E1 or T1 data line
|
|
-
|
linecode
|
Set the type of line-code transmission for the E1 or T1 line
|
|
-
|
loopback
|
Put a T1 or E1 line into loopback mode or disable loopback mode
|
|
-
|
loopback remote
|
Request a remote station to activate or deactivate a line or payload loopback signal on the controller interface. This command is applicable only to a T1 line.
|
|
ds-mode
|
-
|
Set the mode of the controller: e1 or t1
|
|
interface serial
|
-
|
Enter Serial interface or sub interface configuration context
|
|
-
|
ip address
|
Configure the IP address and subnet mask of the interface
|
|
show controllers
|
-
|
Display status information about a controller interface
|
|
show controllers remote
|
-
|
Display controller statistics from a peer station
|
|
show ds-mode
|
-
|
Display the current mode of the controller
|
