Configuring NTP settings

Last Updated : Jul 18, 2024 |
Prolog information
Metadata
Keywords:
Configure the Network Protocol Time (NTP) settings to synchronize the camera time with other devices in the network. You need to specify the IP address of an NTP server, select the time zone to use, and set the time interval at which the camera queries the time and status from the NTP server.
The camera displays the time that you configure with other metadata if you enable video overlay. Before streaming your video, you must ensure that the time is set correctly so that remote participants can see each other's time zones.
  1. In the web interface side pane, click Network.
  2. Click the NTP Settings tab.
  3. For the NTP Time Sync setting, select one of the following options:
    • On: To enable and use NTP time synchronization.
    • Off: To disable NTP time synchronization.
  4. From the Time Zone list, select the time zone to use.
  5. In the Server Address field, type the NTP server IP address.
  6. In the Time Interval(min) field, type the time interval to check the NTP server time and status.
  7. Click Submit.