Configuring the signaling group

Last Updated : Sep 27, 2023 |
Prolog information
Metadata
Keywords:
  1. Enter add signaling-group n, where n is the signaling group number.
  2. Ensure that the Group Type field is set to
  3. Fill in the following fields:
    ADDITIONAL INFORMATION:
    • Max number of NCA TSC: 1 or higher.
    • Max number of CA TSC: 1 or higher.
    • Trunk Group for NCA TSC: Type the number of the previously administered or associated trunk group.
    • Trunk Group for Channel Selection: Type the number of the previously administered or associated trunk group.
    • TSC Supplementary Service Protocol: a.
    • X-Mobility/Wireless Type: DECT.
    • Location for Routing Incoming Calls: blank or the location of the ADMM or RFS.
      Note:
      Administer the Location for Routing Incoming Calls field only when the multiple locations feature is enabled for IP DECT.
    • Near-end Listen Port: Port of the PE.
    • Far-end Listen Port: Port of the ADMM or RFS.
    • Far-end Network Region: Point to the associated network region.
    • Calls Share IP Signaling Connection: n.
    • Interworking Message: PROGress.
    • Enable Layer 3 Test: y for IP trunk supervision.
  4. Select Enter to save your changes.