Configuring the trunk group

Last Updated : Oct 30, 2012 |
Prolog information
Metadata
Keywords:
  1. Enter add trunk-group n, where n is the trunk group number.
    ADDITIONAL INFORMATION:
    Note:
    You must administer this trunk group to use an H.323 signaling group of x-mobility type of DECT.
  2. Ensure that the Group Type field is set to isdn.
  3. Fill in the following fields:
    ADDITIONAL INFORMATION:
    • Direction: two-way.
    • Carrier Medium: H.323.
    • Service Type: tie.
  4. Click Next until you see the Trunk Parameters section.
  5. Fill in the following fields:
    ADDITIONAL INFORMATION:
    • Codeset to Send Display: 0.
    • Supplementary Service Protocol: a.
    • Digit Handling (in/out): overlap/enbloc.
    • Format: Type the numbering format.
      The numbering format no need to be any specific type. For example, IP trunk to the IP DECT can have Private numbering format.
  6. Click Next until you see the Trunk Features section.
  7. Fill in the following fields:
    ADDITIONAL INFORMATION:
    • NCA-TSC Trunk Member: 1 or higher for carrying Message Waiting Indication (MWI) facility.
    • Send Name: y.
    • Send Calling Number: y.
    • Send Connected Number: y.
  8. Click Next until you see the Group Member Assignments section.
  9. Add trunk group members to the numbered Group Member Assignments.
    ADDITIONAL INFORMATION:
    Note:
    The IP DECT supports maximum of 255 simultaneous calls. The IP DECT can choose another available trunk if administered.
    Note:
    Instead of adding the trunk group members on the Group Member Assignments, you can set the Member Assignment Method field to
  10. Select Enter to save your changes.