Static IP address configuration

Last Updated : Jun 09, 2020 |

About this task

The following process is used for static address administration on J100 Series phones.

Procedure

  1. If already shown on the display, select Admin, otherwise press the Menu Menu button and select Admin.
  2. In the Access code field, enter the admin password and press Enter.
  3. Scroll down to IP Configuration and press Select.
  4. Scroll to IPv4 and press Select.
    1. For the Use DHCP option, press Change to set the mode to No.
    2. Press Save.
  5. Scroll to IPv4 again and press Select.
    1. Set Phone to the IP address required for the phone. Use the * key to enter a '.' character in IP addresses.
    2. Scroll down and set Gateway to the IP Office LAN address.
    3. Scroll down and set Netmask to the network subnet mask.
    4. Press Save.
  6. Scroll down to Servers and press Select.
    1. Set the HTTP Server and/or HTTPS Server address to the file server IP address. When both are set, HTTPS is tried before HTTP. If the IP Office is used as the file server, enter the IP Office LAN1 or LAN2 address.
    2. Set the DNS Server address. This must be configured when using static addressing.
    3. Press Save.
  7. Press Back to exit from the IP Configuration and then the Admin menus The phone restarts automatically.
  8. When prompted to enter the user credentials, at the Username prompt enter the user extension number and then the user password.
Related information
J129