Using IP Office System Monitor

DTE Trace Options

Last Updated : Dec 16, 2020 |

Prolog information

Metadata

Keywords:

This tab provides trace options for monitoring the system's DTE port.

Events

Events	Description
DTE Events	Log the status of Flow Control, Modem Controls (Data Terminal Ready (DTR), Data Carrier Detect (DCD)), baud rate changes on the DTE port, and so on.

Packets

Packets	Description
DTE Command Tx	Log the Hayes AT commands send out of the DTE interface.
DTE Command Rx	Log the Hayes AT commands received from the DTE interface.
DTE Filter Tx	Log serial data transmitted out of the DTE interface once connected.
DTE Filter Rx	Log serial data received from the DTE interface once connected.
DTE PPP Tx	Log Framed Point-to-Point Protocol (PPP) packets Transmitted to the DTE interface if the Hayes ATB0 option is set on the port.
DTE PPP Rx	Log Framed PPP packets received from the DTE interface if the Hayes ATB0 option is set on the port.
DTE V110 Tx	Log Framed V.110 packets received from the DTE interface if the Hayes ATB3 option is set on the port.
DTE V110 Rx	Log Framed V.110 packets received from the DTE interface if the Hayes ATB3 option is set on the port.
DTE V120 Tx	Log Framed V.120 packets received from the DTE interface if the Hayes ATB2 option is set on the port.
DTE V120 Rx	Log Framed V.120 packets received from the DTE interface if the Hayes ATB2 option is set on the port.

Default Settings

None of the trace options are enabled by default. See Defaulting the Trace Options.

Send Feedback