The incoming-routing parameters are useful for mapping DNIS numbers directly into the station extension numbers when the Service Provider's DNIS plan does not directly reflect the station extension number length used in the Branch Gateway’s dial plan.
Procedure
Enter incoming-routing<tgnum><mode>, where <tgnum> is an existing ISDN trunk group number and mode is the protocol used for receiving incoming digits.
<mode> can be either enbloc or overlap.
The command line prompt changes to sls-incoming-routing <tgnum>. If you want to remove the incoming routing treatment from the SLS administration, enter exit to leave the second-level incoming-routing context and return to the (super-sls)# context, and then enter clear internal-routing<tgnum><mode>.
If the mode is set to enbloc (in Step 1), you must:
Enter set delete-digits<digits> to define the number of digits to be deleted from a dialed string.
Enter set insert-digits<digits> to define the number of digits to be inserted at the beginning of a dialed string.
Enter set match-pattern<pattern>to define the beginning digit pattern of an incoming alphanumeric dial string to be matched against.
Enter set length<length> to define the length of the dialed string.
If the mode is set to overlap (in Step 1), you may configure only one of the following options:
Enter set delete-digits<digits> to define the number of digits to be deleted from a dialed string.
Enter set insert-digits<digits> to define the number of digits to be inserted at the beginning of a dialed string.
Note:
This action takes place after the deletion task has been completed for the enbloc-receiving mode.
Enter exit to leave the incoming-routing context in SLS.
Enter show to check the incoming-routing administration.
The report lists the incoming-routing parameters for all dial patterns that have been administered. For example:
