For each sink, you can set logging filters by specifying a severity level per application, as follows:

• set logging server condition application severity ip address creates a filter for messages sent to a specified Syslog server.

• set logging file condition application severity creates a filter for messages sent to a log file.

• set logging session condition application severity creates a filter for messages sent to a session log on a terminal screen where:

  • application is the application for which to view messages (use all to specify all applications).

  • severity is the minimum severity to log for the specified application (use none to disable logging messages for the specified application).

  • ip address is the IP address of the Syslog server.

    For example:

    Gxxx-001(super)# set logging server condition dialer critical 147.2.3.66
    Done!
    Gxxx-001(super)# set logging file condition dhcps warning
    Done!
    Gxxx-001(super)# set logging session condition ISAKMP Information
    Done!

You can also filter the show logging file content command by severity for each application, using the same variables as in the set logging file condition command. In addition, you can limit the number of messages to display.

For example, to display the 50 most recent messages from the QoS application with a severity level of critical or higher, enter the following command:

Gxxx-001(super)# show logging file content critical qos 50