set port auto-negotiation- flowcontrol-advertisement |
Set the flow control advertisement for the specified Gigabit Ethernet ports when performing auto-negotiation |
set port duplex |
Configure the duplex type (full or half-duplex) of an Ethernet or Fast Ethernet port or range of ports You can configure Ethernet and FastEthernet interfaces to either full-duplex or half-duplex. The duplex status of a port in auto-negotiation mode is determined by auto-negotiation. When auto-negotiation is enabled, an error message is generated if you attempt to set the transmission type of auto-negotiation Fast Ethernet ports to half-duplex or full-duplex mode. |
set port enable | disable |
Enable or disable a port or a range of ports |
set port flowcontrol |
Set the send/receive mode for flow control frames (IEEE 802.3x or proprietary) for a full-duplex port |
set port level |
Set the default packet priority level for untagged packets |
set port name |
Configure a name for a port |
set port negotiation |
Enable or disable auto-negotiation on the port |
set port speed |
Set the speed of a port or range of ports |
show port auto-negotiation- flowcontrol-advertisement |
Display the flow control advertisement for a Gigabit port used to perform auto-negotiation |
show port edge state |
Display the edge state of a port |
show port flowcontrol |
Display port flow control information |
set port duplex |
Configure the duplex type (full or half-duplex) of an Ethernet or Fast Ethernet port or range of ports |
set port edge admin state |
Determine whether the port is an edge port, for the purposes of RSTP (Rapid Spanning Tree Protocol) Edge port is a treatment assigned to ports for the purposes of RSTP (Rapid Spanning Tree Protocol). For more information about using this command and RSTP configuration in general, see Rapid Spanning Tree Protocol (RSTP). |
set port enable | disable |
Enable or disable a port or a range of ports |
set port flowcontrol |
Set the send/receive mode for flow control frames (IEEE 802.3x or proprietary) for a full-duplex port Each direction (send or receive) can be configured separately. Use the show port flowcontrol command to display port flow control information. |
set port level |
Set the default packet priority level for untagged packets Packets traveling through a port set at normal priority must be served only after packets traveling through a port set at high priority are served. |
set port name |
Configure a name for a port |
set port negotiation |
Enable or disable auto-negotiation on the port When negotiation is enabled, the speed and duplex of a Fast Ethernet port is determined by auto-negotiation. If negotiation is disabled, the user can set the speed and duplex of a Fast Ethernet port. |
set port point-to-point admin status |
Set the connection type of the port to one of the following arguments:
force-true. The port is treated as if it were connected point-to-point force-false. The port is treated as if it were connected to shared media auto. The Branch Gateway tries to automatically detect the connection type of the port |
set port speed |
Set the speed of a port or range of ports An error message is generated if you attempt to set the speed when auto-negotiation is enabled. |
show port edge state |
Display the edge state of a port |
show port flowcontrol |
Display port flow control information |
