For a full description of the commands and their output fields, see Avaya Branch Gateway G450 CLI Reference.
Root level command |
Command |
Description |
clear controller counters |
- |
Reset the controller counters |
controller |
- |
Enter configuration mode for a specific controller |
- |
cablelength long (T1) |
Set transmit and receive levels for a cable longer than 655 feet |
- |
cablelength short (T1) |
Set transmit levels for a cable of length 655 feet or shorter |
- |
channel-group |
Create a channel group logical interface for a PPP or Frame Relay session |
- |
clock source |
Set the clock source for an E1 or T1 controller |
- |
fdl |
Define the type of Facility Data Link loopback that the remote line is requested to enter |
- |
framing |
Set the frame type for an E1 or T1 data line |
- |
linecode |
Set the type of line-code transmission for the E1 or T1 line |
- |
loopback |
Put a T1 or E1 line into loopback mode or disable loopback mode |
- |
loopback remote |
Request a remote station to activate or deactivate a line or payload loopback signal on the controller interface. This command is applicable only to a T1 line. |
ds-mode |
- |
Set the mode of the controller: e1 or t1 |
interface serial |
- |
Enter Serial interface or sub interface configuration context |
- |
ip address |
Configure the IP address and subnet mask of the interface |
show controllers |
- |
Display status information about a controller interface |
show controllers remote |
- |
Display controller statistics from a peer station |
show ds-mode |
- |
Display the current mode of the controller |
