On the SAT screen, type change ip-network-map and press Enter.
The system displays the IP Address Mapping screen.
In the FROM IP Address field, type the starting IP address.
You can type IPv4 or IPv6 address.
The IPv4 address must be a 32-bit address with four decimal numbers, each in the range 0-255 and IPv6 address must be 128–bit address with Hexadecimal numbers.
In the TO IP Address field, type the terminating IP address.
You can type IPv4 or IPv6 address.
The IPv4 address must be a 32-bit address with four decimal numbers, each in the range 0-255 and IPv6 address must be 128–bit address with Hexadecimal numbers.
If the TO IP Address field and the Subnet Mask field are blank , the address in the FROM IP Address field is copied into this field.
In the or Subnet Mask field, specify the mask to be used to get the subnet work identifier from the IP address.
If this field is nonblank on submission, then:
Mask is applied to the FROM IP Address field, putting zeros in the non-masked rightmost bits. The address becomes the stored From address.
Mask is applied to the TO IP Address field, putting 1s in the non-masked rightmost bits. This address becomes the stored To address.
Valid entries are a number in the range 0-32 or blank.
The Subnet Mask field and the TO IP Address field can be submitted blank. When both the fields are blank, the address in the FROM IP Address field is copied into the TO IP Address field
In the Region field, type the network region for the IP address range.
The Region field must contain the network region for this interface. The value can be a number in the range 1-250.
In the VLAN field, specify the virtual LAN value.
The VLAN field sends the VLAN instructions to IP endpoints such as IP telephones and IP softphones. This field does not send instructions to the PROCR.
The VLAN field can take a value between 0-4095 if you want to specify the virtual LAN value. Set the VLAN field to n to indicate that VLAN is disabled.
In the Emergency Location Extension field, type a value 1-7 digits long for the emergency location extension.
The default value is blank. A blank entry is often used for an IP softphone dialing in through PPP from outside your network.
The entry on this screen can be different from the value entered in the Emergency Location Extension field on the Station screen. When such a mismatch occurs, the extension entered on this screen is sent to the Public Safety Answering Point (PSAP).
