This describes the attendant and maintenance status reports which provide an overall view of how the system is performing in real-time. To ensure that the authorized users log into the system, you must click Cancel to log off from the SAT screen after running the monitor system view1 and monitor system view2 commands.
The monitor system commands generate dynamic one-page status reports that summarize the overall current condition of the system and last-hour traffic status.
Using these commands, you can generate two different status report screens. These two screens contain the following information:
monitor system view: Includes the attendant status, maintenance status, and last hour’s traffic data for attendant, hunt, and trunk groups. The screen also shows the date and time of day at which you requested the report.
monitor system view2. Includes attendant status, maintenance status, and last hour’s traffic data for attendant and trunk groups. The screen also shows the date and time of the day at which you requested the report.
Data for attendant and maintenance status updates every 60 seconds. Data for the traffic status updates once every hour because traffic status is obtained from existing measurements collected on an hourly basis.
Note:
Requesting either of the system status reports should be your last request during your current log on. The screens are exited by pressing CANCEL, which also logs you off the system, or after a 30-minute time-out.
