Use test pms-link to verify that the link to the Property Management System (PMS) is administered and performs a series of tests on the link.
See status pms-link for information about the PMS and interpreting its status. See busyout pms-link for information on PMS links. See status link for more details on links.
Prolog information
Metadata
Keywords:
Syntax
test pms-link [ short | long ] [ repeat # | clear ][ schedule ]
short
Execute a series of nondestructive diagnostic tests.
long
Execute a more comprehensive and longer version of the diagnostic tests. This may involve both destructive and nondestructive tests.
repeat #
Number of times to repeat the test, between 1 and 100.
clear
Repeat the test sequence until the alarm is cleared, or until a single test in the sequence fails.
schedule
Specify a time to run the command.
Note:
Specific component maintenance performed on a link sometimes conflicts with link maintenance, because busied-out objects create link setup failure. Frequent link re-setup attempts may delay component recovery. For best results, busyout the link to disable attempted link re-setup.
