With proper permissions you can turn the automatic trace-route feature on and off from the system access terminal (SAT). Use this procedure to administer the Automatic trace-route feature through SAT.
Type change system-parameters ip-options and press Enter.
ADDITIONAL INFORMATION:
The system displays the IP-Options System Parameters page.
Figure: IP-Options System Parameters form
change system-parameters ip-options Page 1 of 4 IP-OPTIONS SYSTEM PARAMETERS IP MEDIA PACKET PERFORMANCE THRESHOLDS Roundtrip Propagation Delay (ms) High: 800 Low: 400 Packet Loss (%) High: 40 Low: 15 Ping Test Interval (sec): 20 Number of Pings Per Measurement Interval: 10 Enable Voice/Network Stats? n RTCP MONITOR SERVER Server IPV4 Address: RTCP Report Period(secs): 5 IPV4 Server Port: 5005 Server IPV6 Address: IPV6 Server Port: 5005 AUTOMATIC TRACE ROUTE ON Link Failure? y H.323 IP ENDPOINT H.248 MEDIA GATEWAY Link Loss Delay Timer (min): 5 Link Loss Delay Timer (min): 5 Primary Search Time (sec): 75 Periodic Registration Timer (min): 20 Short/Prefixed Registration Allowed? n
To enable the automatic trace-route command, set the AUTOMATIC TRACE ROUTE field to ON and Link Failure field to y.
To disable the automatic trace-route command, set the AUTOMATIC TRACE ROUTE field to ON and Link Failure field to n.
ADDITIONAL INFORMATION:
Note:
If you disable the feature, any automatic trace-route currently in progress finishes, and no subsequent trace-route commands are launched or logged (the link failure buffer is cleared).
Press Enter to submit the form.
On the change logging-levels form, enable trace route, and log IP registrations and events.
