NPE_AUDIT

This test is really an audit that sends network update messages to various ports on a board. Since the server does not handle network connections for the gateway, this test is not run.

DS1_DTONE_TS

DS1 CO trunk dial tone seizure test

NEON_TEST

This is run only for those boards that support the neon message lamp. Therefore, it is not needed for R1.

CLK_HEALTH

Reads the LMM loss-of-clock status bits for the specified tone clock board

TDM_NPE_XTALK

Checks if the NPE chip is transmitting on more than one timeslot. Since timeslots are not under the server’s control, this test will not be run.

CONF_TEST

Tests the conference circuit in the NPE. Needs the use of Timeslots; therefore, this test is not run.

MOD16_LOOP

A 1004Hz reflective analog loop around on an analog port. This test requires the use of a tone detector and all TDs are under control of the gateway.

GPP_LP

GPP internal loopback tests is sent through both the I and S channels for a port. A tone detector is needed to detect and report the test pattern.

GPP_NPE

The GPP NPE xtalk test. Server does not handle network connections, so this test is not run.

ICSU_LEDS

Checks the Integrated Channel Service Unit LEDs, which do not exist on the DS1 Media Module.

DIAL_TONE_TS

Detects dial tone.

TRK_AUTO_GRD

This test is for the Australian version of the CO board, TN438.

TRK_PPM_TEST

Factory only test for certain CO trunks; requires a pulse generator.

TRK_HYB_TS

Tests the loop around capabilities of a port’s codec and hybrid circuits.

ONS_HYB_TS

Tests the loop around capability on the codec circuit.

BRI_EPF

Electronic power feed test; not valid for TN2185.

L1_INQ

This function actually encompasses several tests.

SSP_TDMLOOP

This is for the messaging angel, but the server is unaware of the TDM bus.

PRI_TSTCALL

Requires the use of either a data channel or a maintenance test board, neither of which are present.

TDMLP_BRI

The server cannot use the TDM bus.

PPP_TDMLOOP

The server cannot use the TDM bus.