Installing and Administering Avaya J100 Series SIP IP Phones in Avaya Aura®

VLAN parameters

Last Updated : Dec 28, 2020 |

The following configuration parameters are used to configure VLAN functionality on the network switch internal to the phone.


Parameter name	Default value	Description
L2Q	0	Specifies if layer 2 frames generated by the telephone have IEEE 802.1Q VLAN tags. Value operation: 0: Auto. VLAN tagging is turned on when the network can support VLAN tagging and L2QVLAN is non zero. 1: On. VLAN tagging is turned on when the network can support VLAN tagging. The IP phone sends tagged frames with VLAN = L2QVLAN, even if L2QVLAN is set to 0. 2: Off. VLAN functionality is disabled. L2Q is configured through: Local admin procedure A name equal to value pair in DHCPACK message SET command in the Settings file DHCP option 43 LLDP
VLANTEST	60	Specifies the number of seconds that the phone waits prior to failing back to a different VLAN ID if no response is received from the DHCP server. Valid values are 0 through 999. Value operation: 0: The phone continues to attempt a DHCP REQUEST forever. VLANTEST is configured through: Settings file A name equal to value pair in DHCPACK message
VLANSEP	1	Specifies whether the VLAN separation is enabled or disabled by the built-in Ethernet switch. Value operation: 0: Disabled 1: Enabled
VLANSEPMODE	1	Specifies whether the VLAN separation is enabled or disabled. Value operation: 0: Disabled 1: Enabled VLANSEPMODE is configured through the Settings file.
PHY2TAGS	0	Determines whether or not VLAN tags are stripped on Ethernet frames going out of the Computer (PC) port. Value operation: 0: Strip tags. VLAN tags are stripped from Ethernet frames leaving the computer (PC) port of the phone. 1: Does not strip tags. VLAN tags are not stripped from Ethernet frames leaving the Computer (PC) port of the phone. PHY2TAGS is configured through the Settings file.
L2QVLAN	0	Specifies the voice VLAN ID to be used by IP phones. Valid values are 0 through 4094. L2QVLAN is configured through: Local admin procedure A name equal to value pair in DHCPACK message SET command in the Settings file DHCP option 43 LLDP
PHY2VLAN	0	Specifies the value of the 802.1Q VLAN ID used by frames forwarded to and from the secondary (PHY2) Ethernet interface when VLAN separation is enabled. Valid values are 0 through 4094. PHY2VLAN is configured through: SET command in a settings file LLDP
L2QAUD	6	Specifies the value of the VLAN priority portion of the VLAN tag when the phone generates tagged Ethernet frames from the internal CPU of the phone. These values are inserted into the VLAN tag for audio frames (RTP, RTCP, SRTP, SRTCP). All other frames except those specified by the L2QSIG parameter are set to priority 0. Valid values are 0 through 7. L2QAUD is configured through: SET command in the Settings file LLDP
L2QSIG	6	Specifies the layer 2 VLAN priority value for signaling frames generated by the phone. Valid values are 0 through 7. L2QSIG is configured through: SET command in the Settings file AADS LLDP Setting this parameter through AADS or LLDP overwrites values in the settings file.
PHY2PRIO	0	Specifies the layer 2 priority value to be used for frames received on the secondary Ethernet interface when VLAN separation is enabled. The parameter is not supported when VLANSEPMODE is 1. Valid values are 0 through 7. Note: J129 does not support this parameter.

Send Feedback