ds1

Last Updated : Apr 02, 2020 |
Use the ds1 command within the sls context to enter a second-level subcontext for administering DS1 trunks for SLS. After issuing this command, the prompt changes to sls-ds1-<port-address>. Type exit to leave the DS1 context, and return to the sls context.
Prolog information
Metadata
Keywords:

Syntax

ds1 slot-address

Parameters

Parameter
Description
Possible Values
Default Value
slot-address
The physical module address on the gateway
G 450
Note:
The DS1 port address must agree with the slot assignment administration. For more information, see set slot-config.

G4xx slot and board matrix for SLS

G 450 Media Module
Description
Permitted slots
SLS configured?
MM710
One T1/E1 trunk port
v1, v2, v3, v4, v5, v6, v7, v8
Yes

User Level

read-write

Context

sls

Example

To enter the subcontext for administering DS1 trunks for SLS at the port address v3:
G4xx-001 (super-sls)# ds1 v3
G4xx-001 (sls-ds1-<v3>)#

Sub-commands

The following commands are available once you are inside the sls > ds1 context:
DS1 sub-commands
set bearer-capability
set bit-rate
set channel-numbering
set connect
set country-protocol
set interface
set interface-companding
set long-timer
set name
set protocol-version
set side
set signaling-mode
show (ds1)

Additional SLS commands

set sls, show ds1, show sls, sls