Firmware management

Last Updated : Sep 19, 2023 |
Prolog information
FTP is enabled by default on Media Gateways and media modules. You can upload firmware using Media Gateways CLI, so FTP is unnecessary. You can also upgrade Media Gateways and media modules using the SCP server or a USB stick.
Firmware management CLI commands
Command
Description
copy ftp module
Upgrades the firmware on a media module from an FTP server.
copy ftp SW_imageA
Upgrades the Branch Gateway firmware into Bank A from an FTP server.
copy ftp SW_imageB
Upgrades the Branch Gateway firmware into Bank B from an FTP server.
copy tftp module
Upgrades the firmware on a media module from a TFTP server.
copy tftp SW_imageA
Upgrades the Branch Gateway firmware into Bank A from a TFTP server.
copy tftp SW_imageB
Upgrades the Branch Gateway firmware into Bank B from a TFTP server.
copy scp SW_imageA
Upgrades the Branch Gateway firmware into Bank A from an SCP server.
copy scp SW_imageB
Upgrades the Branch Gateway firmware into Bank B from an SCP server.
copy usb module
Upgrades the firmware on a media module from the USB mass storage device.
copy usb SW_image
Upgrades the Branch Gateway firmware into Bank A or into Bank B, from the USB mass storage device.
copy https module
Upgrades the firmware on a media module from the HTTP or HTTPS server.
copy https SW_imageA
Upgrades the Branch Gateway firmware into Bank A from the HTTP or HTTPS server.
copy https SW_imageB
Upgrades the Branch Gateway firmware into Bank B from the HTTP or HTTPS server.
copyedge scp SW_imageA
Upgrades the Branch Gateway firmware into Bank A from an SCP server through Avaya SBC tunnel.
.
copyedge scp SW_imageB
Upgrades the Branch Gateway firmware into Bank B from an SCP server through Avaya SBC tunnel.
.
copyedge scp module
Upgrades the firmware on a media module from an SCP server through Avaya SBC tunnel.
.
dir
Lists all files in the USB mass storage device connected to the Branch Gateway.
.
set boot bank
Sets the default bank from which firmware is loaded during start-up.
show boot bank
Displays the bank from which the Branch Gateway is currently set to load its firmware upon start-up or reset.
.
show download software status
Displays the status of the firmware download process.
show image version
Displays the software version of the image on both memory banks of the device.
.
show third-party copyrights
Displays the copyright notices and open-source license information for third-party software used within Branch Gateway.