Last Updated : Aug 25, 2023 |
Prolog information
IPv6 configuration commands
Root-Level Command
First-Level Command
Description
ipv6 default-gateway
Define the default IPv6 gateway .
ipv6 icmp destination-unreachable
Enable generation of ICMPv6 Destination Unreachable messages.
ipv6 icmp echo-reply
Enable replies to ICMPv6 Echo Request messages sent to a multicast address.
ipv6 icmp in-rate-limit
Limit ingress rate of ICMPv6 messages.
ipv6 icmp out-rate-limit
Limit egress rate of ICMPv6 messages.
ipv6 icmp redirect
Accept ICMPv6 Redirect messages.
ipv6 nd dad attempts
Set IPv6 Duplicate Address Detection Transmits.
ipv6 nd timeout
Set IPv6 neighbors timeout.
ipv6 route
Add a static route for a remote IPv6 network.
interface vlan
ipv6 address
Set an IPv6 address for this interface.
interface vlan
ipv6 admin-state
Set the administrative state of this IPv6 interface.
interface vlan
pmi6
Set this interface's global (or link-local) IPv6 address to be the IPv6 primary management interface.
show ipv6 icmp
Display status of ICMPv6 variables.
show ipv6 interface
Display interfaces IPv6 information.
show ipv6 nd config
Display IPv6 neighbor discovery configuration.
show ipv6 neighbors
Display IPv6 neighbor cache entries.
show ipv6 route
Display the IPv6 routing table.
set qos rtcp monip6
Sets RTCP monitor IPv6 address.
ping6
Ping6 utility.
traceroute6
Traceroute utility for IPv6.
show ipv6 traffic
Display IPv6 counters.
clear ipv6 traffic
Clear IPv6 counters.
show ipv6 route static
Display static IPv6 routes.
show tcp connections ipv6
Display the TCP connection status over IPv6.