You must configure CM for SLS using manual CLI entry of SLS administration. Perform the configuration during the initial administration of the host CM server.
Access the CM administrative SAT interface.
At the SAT, enter change node-names ip to display the IP Node Names screen.
For example:
change node-names ip Page 1 of 2 IP NODE NAMES Name IP Address gateway1 198.152.1.200 . . . (X of X administered node-names were displayed ) Use 'list node-names' command to see all the administered node-names Use 'change node-names ip xxx' to change a node-name 'xxx' or add a node-name
Type the IP address of the Branch Gateway in the IP Address field.
Submit the screen.
At the SAT, enter change system-parameters mg-recovery-rule1 to display the System Parameters Media Gateway Automatic Recovery Rule screen.
Type a description of the rule in the Rule Name field.
Set the Migrate H.248 MG to primary field to
ADDITIONAL INFORMATION:
Note:
The
Submit the screen.
At the SAT, enter display media-gateway1 to display the Media Gateway screen.
Verify the following fields:
ADDITIONAL INFORMATION:
Name field (20 characters maximum) must match the administered name of the gateway.
Max Survivable IP Ext field only appears when the Type field is
The current maximum product limits enforced by the SLS gateway’s firmware module is 150.
These limits are enforced due to resource considerations in the given gateway.
Important:
Since the VoIP resources on the Branch Gateway are limited, the Max Survivable IP Ext field should not exceed these values.
At the SAT, enter change stationextension to display the Station screen.
