Summary of switch Ethernet port configuration CLI commands

Last Updated : May 02, 2023 |
Prolog information
Metadata
Keywords:
For more information about these commands, see Avaya Branch Gateway G430 CLI Reference.
Command
Description
set port duplex
Configure the duplex type (full or half-duplex) of an Ethernet or Fast Ethernet port or range of ports
You can configure Ethernet and FastEthernet interfaces to either full-duplex or half-duplex. The duplex status of a port in auto-negotiation mode is determined by auto-negotiation. When auto-negotiation is enabled, an error message is generated if you attempt to set the transmission type of auto-negotiation Fast Ethernet ports to half-duplex or full-duplex mode.
set port enable | disable
Enable or disable a port or a range of ports
set port flowcontrol
Set the send/receive mode for flow control frames (IEEE 802.3x or proprietary) for a full-duplex port
set port level
Set the default packet priority level for untagged packets
set port name
Configure a name for a port
set port negotiation
Enable or disable auto-negotiation on the port
set port speed
Set the speed of a port or range of ports
show port auto-negotiation- flowcontrol-advertisement
Display the flow control advertisement for a Gigabit port used to perform auto-negotiation
show port edge state
Display the edge state of a port
show port flowcontrol
Display port flow control information
set port duplex
Configure the duplex type (full or half-duplex) of an Ethernet or Fast Ethernet port or range of ports
set port edge admin state
Determine whether the port is an edge port, for the purposes of RSTP (Rapid Spanning Tree Protocol)
Edge port is a treatment assigned to ports for the purposes of RSTP (Rapid Spanning Tree Protocol). For more information about using this command and RSTP configuration in general, see Rapid Spanning Tree Protocol (RSTP).
set port enable | disable
Enable or disable a port or a range of ports
set port flowcontrol
Set the send/receive mode for flow control frames (IEEE 802.3x or proprietary) for a full-duplex port
Each direction (send or receive) can be configured separately. Use the show port flowcontrol command to display port flow control information.
set port level
Set the default packet priority level for untagged packets
Packets traveling through a port set at normal priority must be served only after packets traveling through a port set at high priority are served.
set port name
Configure a name for a port
set port negotiation
Enable or disable auto-negotiation on the port
This command applies to the Fast Ethernet port. When negotiation is enabled, the speed and duplex of a Fast Ethernet port is determined by auto-negotiation. If negotiation is disabled, the user can set the speed and duplex of a Fast Ethernet port.
set port speed
Set the speed of a port or range of ports
An error message is generated if you attempt to set the speed when auto-negotiation is enabled.
show port edge state
Display the edge state of a port
show port flowcontrol
Display port flow control information