IP DECT Gateway Installation Summary

Last Updated : Mar 25, 2013 |

About this task

The configuration process for the IP DECT Gateway is very similar to that for an IP base station. In a new Avaya Wireless DECT system installation, Avaya recommends that the IP DECT Gateway is installed as the master base station for the system. This does not affect the allowed number of IP and or digital base stations.

The installation of a IP DECT Gateway as a master base station can be done as part of either a provisioned installation or non-provisioned installation. If the IP DECT Gateway is being added to an existing system, it can be added in the same way as for a new slave base station.

A summary of the installation stages is as follows:

Procedure

  1. Install in rack.
  2. Attach power cable.
  3. Connect the unit to the LAN using the LAN1 port.
  4. Connect the digital base station cables.
  5. Power on the unit.
  6. Access and configure the unit in the same way as for a base station. The configuration required will depend on whether the IP DECT Gateway is being used as a master base station for the system.
    Note:

    If an IP DECT Gateway is being installed, Avaya recommends configuring the IP DECT Gateway as the master base station for the system. To configure the IP DECT gateway as a master base station, see Master Base Station Setup.

Related information
IP DECT Gateway Installation