The following table lists the filters that you can select in SysMonitor, and describes outputs that each filter generates. This information is intended for technical support personnel when troubleshooting the SSL VPN service.
Name
Description
Configuration
Displays information about when the SSLVPN service was added, modified, or deleted.
Session
Displays information about the status of the SSL VPN service, such as whether the tunnel is in service or in fallback, or trying to connect. When the SSL VPN service is connected, this shows the negotiated SSL VPN tunnel parameters with AVG.
SessionState
Displays information about the state when an event occurs. The defined states are: Idle, Connecting, Connected, Disconnecting, WaitingToStart, and NeedsRestart.
Fsm
Used for UDP connections. UDP is not supported for the SSL VPN service; no output is generated.
Socks
Displays the SOCKS stack events triggered by signalling messages.
SocksState
Displays the internal states of the SOCKS stack when SOCKS5 signalling messages are processed.
Heartbeat
Displays information about when heartbeat messages are sent and received.
Keepalive
Used for UDP connections. UDP is not supported for the SSL VPN service; no output is generated.
SignalingPktRx
Displays a byte stream of SOCKS signaling packets received from the AVG.
SignalingPktTx
Displays a byte stream of SOCKS signaling packets sent to the AVG.
DataPktRx
Displays a subset of the datagram, beginning with the data packet received by the SSL VPN tunnel from AVG and passed on to the IP Office system.
DataPktTx
Displays a subset of the datagram, beginning with the data packet sent by the SSL VPN tunnel interface to the AVG.
TunnelInterface
Displays information about the interactions between the SSL VPN tunnel interface and the IP Office IP stack.
TunnelRoutes
Displays information about the split tunneling routes installed in and removed from the IP Office routing table.
