Connecting the EM200 expansion module to a power source

Last Updated : Jan 03, 2022 |

About this task

Before you connect power to G430, you must connect the EM200 expansion modules to a power source.

Warning:

If you need to move the EM200 expansion modules in a working system consisting of G430 and one or two EM200s housing media modules, you must disconnect the EM200 from a power source before reconnecting the expansion cable to another slot.

Perform the following procedure for each EM200 connected to G430.

Procedure

  1. Connect the power cable to the power connector on the EM200 back panel.
  2. Plug the power cable into a mains socket.

    The V5-V6 LED on the EM200 front panel lights if the EM200 is connected to the CONNECTOR OUT 1 connector on the rear panel of G430. This indicates that the two media module slots are considered slot 5 and slot 6 of G430.

    The V7-V8 LED on the EM200 front panel lights if the EM200 is connected to the CONNECTOR OUT 2 connector on the rear panel of G430. This indicates that the two media module slots are considered slot 7 and slot 8 of G430.

    The PWR LED on the front panel lights, indicating the EM200 is powered.