Installing an Avaya Aura® Device Services cluster

Last Updated : Aug 07, 2018 |
Prolog information
Metadata
Keywords:
Use this procedure to install an Avaya Aura® Device Services cluster.
Before you begin
Ensure that you understand the Avaya Aura® Device Services prerequisites. The prerequisites for installing an Avaya Aura® Device Services cluster are the same as for installing an individual Avaya Aura® Device Services server.
Note:
The Avaya Aura® Device Services cluster must be installed by a Linux user with sudo privileges, created during the pre-configuration setup. The User ID (UID) of the Linux user that performs the installation must be the same on all the Avaya Aura® Device Services nodes. After a user is configured, run the following command to display the ID of the user:id -u <user_name>For example:id -u Avaya
  1. Install the initial node.
    ADDITIONAL INFORMATION:
    For more information, see Installing Avaya Aura Device Services.
  2. Install one or more additional nodes.
    ADDITIONAL INFORMATION:
    Important:
    Proceed with the next steps only after installing all the Avaya Aura® Device Services nodes.
  3. After all the required cluster nodes are installed, configure the SSH/RSA Public/Private keys on the seed node.
    ADDITIONAL INFORMATION:
    For more information, see Configuring RSA public and private keys for SSH connections in a cluster.
  4. Start every node in the cluster individually.
    ADDITIONAL INFORMATION:
    Using a Linux shell for each Avaya Aura® Device Services server in the cluster, run the following command:svc aads start