Creating security groups

Last Updated : Dec 03, 2020 |
Prolog information
Metadata
Keywords:
AWS uses security groups to control inbound and outbound traffic. For software-only installation, you must create the following security groups:
  • Avaya Aura® Device Services security group.
    This security group uses the primary eth0 interface.
  • Utility Server security group.
    This security group uses the secondary eth1 interface.
  • Avaya Aura® Device Services load balance security group.
  • Utility Server load balance security group.
  1. On the Amazon Web Services Management console, navigate to Services EC2 Security group.
  2. Click Create Security Group.
  3. In Security group name, type a name of your choice.
    ADDITIONAL INFORMATION:
    For example: AADS security group eth0
  4. In Description, type a description for the group.
  5. From VPC, select the Virtual Private Cloud that you plan to use for Avaya Aura® Device Services.
  6. Configure the inbound and outbound traffic rules for the group.
    ADDITIONAL INFORMATION:
    Fore more information, see the Traffic rules section for the appropriate group.
  7. Repeat steps 2 to 6 to create the additional required security groups.
  8. Make a note of the security group ID of the Utility Server security group.
    ADDITIONAL INFORMATION:
    You require this ID when configuring security groups for the secondary network interface.
Related links
Initial setup for software-only deployments on Amazon Web Services
Traffic rules for the Avaya Aura Device Services security groupTraffic rules for the Utility Server security groupTraffic rules for the Avaya Aura Device Services load balancer security groupTraffic rules for the Utility Server load balancer security group