Configuring A10 for LDAP authentication

Last Updated : Feb 01, 2018 |
Prolog information
Metadata
Keywords:
The following procedure describes how to configure A10 for performing LDAP authentication before the HTTP requests are redirected to the backend Avaya Aura® Device Services server.
  1. To create an LDAP server, do the following:
    1. In the ACOS administrative interface, click the Config Mode tab.
    2. Select SecurityAuthenticationServer.
    3. Click Add twice.
    4. In the General section, configure the connection details for the LDAP server.
    5. Click OK and then click Save.
  2. To enable HTTP log on, do the following:
    1. In the ACOS administrative interface, click the Config Mode tab.
    2. Select SecurityAuthenticationLogon.
    3. Click Add.
    4. Configure the HTTP logon settings.
    5. Click OK and then click Save.
  3. To configure the HTTP relay, do the following:
    1. In the ACOS administrative interface, click the Config Mode tab.
    2. Select SecurityAuthenticationRelay.
    3. Click Add.
    4. Configure the authentication relay settings.
    5. Click OK and then click Save.
  4. To create an authentication template, do the following:
    1. In the ACOS administrative interface, click the Config Mode tab.
    2. Select SecurityAuthenticationTemplate.
    3. Click Add.
    4. Configure the authentication template.
    5. Click OK and then click Save.
  5. To edit a virtual service, do the following:
    1. In the ACOS administrative interface, click the Config Mode tab.
    2. Select SLBServiceVirtual Service.
    3. Click Edit.
    4. Edit the virtual service.
    5. Click OK and then click Save.
Related links
Remote access configuration