|
ABORT |
System resources are unavailable to run the command. Try the command again at one-minute intervals up to 5 times. |
0 |
ABORT |
Internal system error. Retry the command at one-minute intervals up to 5 times. |
1005 |
ABORT |
A DS1 interface media module could not be reset because it is supplying the online synchronization reference. Use set sync to designate a new DS1 interface media module as the online reference, then try the reset again. |
1010 |
ABORT |
An attempt was made to busyout an object that was already busied out. |
1011 |
ABORT |
An attempt was made to release an object that was not first busied out. |
1015 |
ABORT |
A reset of this media module requires that every maintenance object on it be in the out-of-service state. Use busyout board to place every object on the media module in the out-of-service state, and try the reset again. |
1026 |
ABORT |
The specified TDM bus cannot be busied out because the control channel or system tones are being carried on it. Use set tdm PC to switch the control channel and system tones to the other TDM bus. |
1426 |
ABORT |
The port cannot be released because the gateway has the Emergency Transfer Mode set. The user must use the command line interface of the gateway to clear the mode. |
2012 2500 |
ABORT |
Internal system error. |
2100 |
ABORT |
System resources to run this command are unavailable. Try the command again at one-minute intervals up to 5 times. |
62524 62525 62526 |
ABORT |
Maintenance is active on the maximum number of maintenance objects that the system can support. A common cause is that the system contains many administered stations or trunks with installed media modules that are not physically connected. Resolve as many alarms as possible on the station and trunk MOs, or busyout these MOs to prevent maintenance activity on them. Then try the command again. |
|
NO BOARD |
The media module is not physically installed. |
|
FAIL |
See the applicable maintenance object information in Maintenance Commands for Avaya Aura® Communication Manager, Branch Gateways and Servers. |
|
PASS |
The requested action successfully completed. If the reset command was used, the media module is now running and must be tested. |
