test board

Last Updated : Jul 28, 2023 |

Run tests on specified media module.

Note:

Some tests can be disabled by administration.

Important:

You cannot perform the destructive long tests on a Switch Node Interface (SNI) board unless the board has been busied out.

Syntax

test board  location  [ repeat #]
location

Physical location of the media module.

repeat #

(Optional) The number of times to repeat the command. The default is 1.

short

Run short test sequence.

long

Run long test sequence.

clear

Repeats the test sequence until any active alarms against the maintenance object are cleared by the passing of tests, or until any test in the sequence fails.

Description

Use test board to perform a set of hardware diagnostic tests on a specified media module. The system first validates that the board exists at the specified location. Then, based on the logical type of board (for example, Analog, Digital, Hybrid), a series of tests performs diagnostics on the board and then returns results of the tests along with any possible error codes.

The default is to run the short test sequence after.

Example


test board  1v4