load-interval

Last Updated : Nov 06, 2012 |

Sets the load calculation interval for an interface. Use no load-interval to restore the load calculation to its default value.

Note:

The load interval must be in increments of 30 seconds.

Syntax

load-interval seconds

no load-interval


Parameter	Description	Possible Values	Default Value
seconds	The load calculation interval, in seconds. This parameter must be divisible by 30.	30-600	300

read-write

Interface: FastEthernet (L2, L2-L3, PPP L2, PPP L2-L3), VLAN (L2, L2-L3), Loopback (L2, L2-L3), Tunnel (L2, L2-L3), Dialer (L2, L2-L3), USB-modem

To set the load calculation interval to 60 seconds:

Gxxx-001(if:Dialer 1)# load-interval 60

Send Feedback