Create a Normal Service: The Account Name and password is presented to the remote end, therefore must match the User name and password configured at Site B. The Encrypted Password option can only be used if the remote end also supports CHAP.

Create a User: Under the Dial In tab tick Dial In On. This User account is used to authenticate the connection from the Site B. As the Service and User have the same name these two configuration forms are automatically linked and become an Intranet Service. The User password is displayed at the bottom of the Service tab as the Incoming Password.

Name: SiteB

Dial In | Dial In On: Enabled.

Create a RAS service: If CHAP is to be used on this link, then the Encrypted Password option must be checked in the Service and in the RAS service. The name of the RAS service must match the name of the Service at Site B. If the RAS service is given the same name as the Service and User, they are automatically linked and become a WAN Service. Ensure that the Encrypted Password option is not checked when using a WAN Service.

Edit the WANPort: Note - do not create a new WANPort, this is automatically detected. If a WANPort is not displayed, connect the WAN cable, reboot the Control Unit and receive the configuration. The WANPort configuration form should now be added.

RAS Name: SiteA

Create an IP Route: The IP Address is the network address of the remote end. Under Destination select the Service created above.

Create a new Line: The Line Number and Line Group ID must be unique, in other words, not used by any other line. The Gateway IP Address is the IP Address of the Control Unit at the remote end. The Compression Mode used is dependent on the Voice Compression Card the Control Unit is running and the speed of the link.

Create a Short Code: To route all calls where the number dialed starts with 8 via Line Group ID 1, therefore via the VPN Line created above.

Short Code: 8N

Telephone Number: N

Line Group ID: 1

Feature: Dial