Use this procedure to administer H.323 trunk link recovery.
Procedure
At the SAT interface, type list signaling-group and press Enterto display a list of the administered signaling groups. Find the H.323 signaling group(s) in the list.
Type change signaling-groupn, where n is an administered H.323 signaling group.
display signaling-group 2 Page 1 of 6
SIGNALING GROUP
Group Number: 2 Group Type: h.323
SBS? n Remote Office? n Max number of NCA TSC: 10
Q-SIP? n Max number of CA TSC: 0
IP Video? n Trunk Group for NCA TSC: 2
Trunk Group for Channel Selection: 2 X-Mobility/Wireless Type: NONE
TSC Supplementary Service Protocol: a Network Call Transfer? n
Location for Routing Incoming Calls: T303 Timer(sec): 10
H.245 DTMF Signal Tone Duration(msec):
Near-end Node Name: procr Far-end Node Name: S8300
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 1
LRQ Required? n Calls Share IP Signaling Connection? y
RRQ Required? n
Media Encryption? n Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: out-of-band Direct IP-IP Audio Connections? y
Link Loss Delay Timer(sec): 90 IP Audio Hairpinning? y
Enable Layer 3 Test? y Interworking Message: PROGress
H.323 Station Outgoing Direct Media? n DCP/Analog Bearer Capability: 3.1kHz
Type the number of seconds to retain the call state information in the Link Loss Delay Timer field (1-180 seconds, default is 90).
If you want Communication Manager to run the Layer 3 test that verifies that all connections known at the near-end are recognized at the far-end, type y in the Enable Layer 3 Test field.
Note:
The default value is y (test enabled), however some systems, possibly older Communication Manager releases, respond incorrectly to this test. Set the value to n in these cases. If this field is administered as y (test enabled) and the Far-end Node Name does not have an administered IP address, then you cannot submit the form.
Note:
The Far-end Node Name must have an administered IP address, otherwise the Layer 3 test aborts.
