Viewing IP connection status of a station

Last Updated : Apr 21, 2014 |

About this task

Use the status station command to determine the type of active IP connection.

Procedure

  1. Type status station extension to open the GENERAL STATUS screen.
  2. Move to the AUDIO CHANNEL section of the form. 
    
status station 5141012                                           Page   x  of   x
AUDIO CHANNEL Port: S00001
              Switch-End Audio Location:
            IP Address                               Port  Node Name       Rgn
Other-End:
  Set-End:
Audio Connection Type: ip-tdm
  3. Review the following field:

    Field

    Value

    Audio Connection Types

    • ip-tdm - connection is from one endpoint through the TDM bus and back through the Media Processor

    • ip-hairpin - connection is between two endpoints that go through the Media Processor but not through the TDM bus

    • ip-direct - connection goes directly between two endpoints without going through the Media Processor

    • ip-idle - the endpoint is idle and not connected
  4. Exit the screen.