Collecting Feature Access Codes data

Last Updated : Nov 06, 2012 |

Procedure

  1. At the SAT, enter display system-parameters customer-options to display the Customer Options screen.
  2. Scroll to page 5 and determine how the Multinational Locations or Multiple Locations fields are set:

    • If either of these fields is set to y (enabled), then proceed to Step 3.

    • If these fields are set to n (disabled), at the SAT, enter display feature-access-codes and gather the following FAC information:

      • Contact Closure Open Code

      • Contact Closure Close Code

      • Contact Closure Pulse Code

      • Auto Route Selection (ARS) Access Code1

      • Auto Route Selection (ARS) Access Code2

      • ARS FAC

      • CAS Remote Hold/ Answer Hold-Unhold Access Code

  3. Look up the location of the gateway, as follows:
    1. At the SAT, enter list media-gateway to get the gateway’s number.
    2. At the SAT, enter display media gateway number, where number is the gateway number you obtained in Step a.

      This provides you with the location field value.

      • If the gateway has an administered location, at the SAT, enter display locations number, where number is the administered location number. If there is an ARS entry for the given location, you must use this value exclusively in the SLS data set.

      • If there is no administered location, at the SAT, enter display feature-access-codes and gather the FAC information listed in Step 2.