For more information about these commands, see Avaya Branch Gateway G430 CLI Reference.
Command |
Description |
set lldp re-init-delay |
Set the delay from when a port is set to LLDP disable until re-initialization is attempted |
set lldp system-control |
Enable or disable the LLDP application globally per device or stack |
set lldp tx-delay |
Set the TxDelay, which is the minimal delay in seconds between successive LLDP frame transmissions, on each port |
set lldp tx-hold-multiplier |
Set the TxHoldMultiplier, which is a multiplier on the TxInterval that determines the actual TTL value sent in an LLDP frame |
set lldp tx-interval |
Set the TxInterval, the interval at which the device transmits LLDP frames |
set port lldp |
Change the administrative LLDP status of a port |
set port lldp tlv |
Enable or disable the transmission of the optional TLVs on a per port basis |
show lldp |
Display the LLDP information received on each port |
show lldp config |
Display the global LLDP configuration |
show port lldp config |
Display port-level LLDP configuration |
show port lldp vlan-name config |
Show the VLANs that are being transmitted on a specific port |
