You can connect a Branch Gateway to a power source after you have mounted the Branch Gateway, installed the PSU, media modules, and attached the supplementary ground conductor. You can order a Branch Gateway with one or two PSUs.
Procedure
Using the AC power cords supplied with the Branch Gateway, connect the AC power cord to the AC connector on the Branch Gateway back panel. If a DC power cord is also supplied, connect the DC power cord to the DC connector on the Branch Gateway back panel.
Plug the AC power cable into an AC wall outlet. If supplied, plug the DC power cable into a DC power source.
When the Branch Gateway is switched ON, the PWR LED on the front panel comes ON. The CPU LED comes ON if the firmware is running.
At least one LED on each media module, except S8300 Server, comes ON and then goes OFF after about 20 seconds.
