Removing power supply units

Last Updated : Feb 25, 2022 |

About this task

You can remove the power supply unit (PSU) for the simplicity of installation before unpacking the Branch Gateway.

Procedure

  1. Open the package.
  2. Turn the Branch Gateway, so that the rear panel points up.
  3. To remove the PSU, do the following:
    1. Loosen two PSU captive screws from each side of the PSU.
    2. Hold the two side handles and pull the PSU up and out.
    3. Place the PSU carefully on a flat surface.

    If you ordered two PSUs, remove them.