linecode (E1)

Last Updated : Nov 06, 2012 |

Specifies the type of line-code transmission for the an E1 line. Use no linecode to restore the default line-code value of hbd3.

Note:

Normally the E1 service provider determines which type of line-code is required for your E1 circuit.

Syntax

linecode {ami|hdb3}


Parameter	Description	Possible Values	Default Value
ami	Keyword that specifies the Alternate Mode Inversion line-code type
hbd3	Keyword that specifies the High-Density Bipolar 3 line-code type

read-write

interface:Controller (E1)

To set the line-code type to ami:

Gxxx-001(super-controller:5/1)# linecode ami

Send Feedback