Avaya G450 Branch Gateway CLI Reference

PPP encapsulation

Last Updated : Jul 02, 2019 |

Important:

These commands are not allowed when FIPS mode is enabled. Note that Frame-relay is also not allowed when FIPS mode is enabled.

Table 1: PPP encapsulation CLI commands
Root level command	First level command	Description
interface serial		Enter Serial interface or sub-interface configuration mode
	encapsulation	Set the encapsulation mode for a Serial interface: PPP or frame-relay
	ip address	Configure the IP address and subnet mask of the interface
	keepalive (PPP)	Enable PPP keepalive, in order to maintain a persistent connection
	ppp timeout ncp	Set the maximum time, in seconds, that PPP allows for negotiation of a network layer protocol
	ppp timeout retry	Set the maximum time to wait for a response during PPP negotiation
show interfaces		Display interface configuration and statistics for a particular interface or all interfaces

Send Feedback