ds1

Last Updated : Apr 02, 2020 |

Use the ds1 command within the sls context to enter a second-level subcontext for administering DS1 trunks for SLS. After issuing this command, the prompt changes to sls-ds1-<port-address>. Type exit to leave the DS1 context, and return to the sls context.

Syntax

ds1 slot-address

Parameters

Parameter

Description

Possible Values

Default Value

slot-address

The physical module address on the gateway

G 450
Note:

The DS1 port address must agree with the slot assignment administration. For more information, see set slot-config.

G 450 Media Module

Description

Permitted slots

SLS configured?

MM710

One T1/E1 trunk port

v1, v2, v3, v4, v5, v6, v7, v8

Yes

User Level

read-write

Context

sls

Example

To enter the subcontext for administering DS1 trunks for SLS at the port address v3:

G4xx-001 (super-sls)# ds1 v3
G4xx-001 (sls-ds1-<v3>)#

Sub-commands

The following commands are available once you are inside the sls > ds1 context:

DS1 sub-commands

set bearer-capability

set bit-rate

set channel-numbering

set connect

set country-protocol

set interface

set interface-companding

set long-timer

set name

set protocol-version

set side

set signaling-mode

show (ds1)

Additional SLS commands

set sls, show ds1, show sls, sls