set signaling-mode

Last Updated : Nov 06, 2012 |

Sets the signaling mode for the DS1 facility in SLS.

Note:

This command is valid only for DS1.

If this command is invoked to change the transmission rate and the DS1 facility and associated signaling group have already been provisioned, the command is blocked and a warning message, Administrative change is in violation with existing trunk member provisioning, is displayed.

Syntax

set signaling-mode mode-type

Parameters

Parameter

Description

Possible Values

Default Value

mode-type

The signaling mode for the DS1 facility.

  • cas – Out-of-band signaling for E1 service, yielding thirty 64kbps B-channels for voice transmission

  • robbedbit – In-band signaling for T1 service, yielding twenty-four 56kbps B-channels for voice transmission

  • idsnpri – Use this setting for either T1 or E1 ISDN Primary Rate service (supports both FAS and NFAS)

  • isdnext – NFAS T1 or E1 ISDN service for:

    • T1 facility in which all 24 channels are for bearer transport

    • E1 facility in which all 31 channels are for bearer transport

cas

robbedbit

idsnpri

isdnext

idsnpri

User level

read-write

Context

sls > ds1

Example

To set the signaling mode for the DS1 facility to PRI:

Gxxx-001 (sls-ds1-<port address>)# set signaling-mode isdnpri