set contact-closure admin

Last Updated : Nov 06, 2012 |

Specifies how the contact closure relay is controlled.

Note:

The set contact-closure pulse-duration command does not affect the set contact-closure admin manual command.

Syntax

set contact-closure admin module/port:relay {mgc | manual-trigger | manual-off}


Parameter	Description	Possible Values
module	Module number of the contact closure port	10
port	Port number of the contact closure port	2
relay	Contact closure relay	1 , 2
mgc	Contact closure is controlled by the call controller
manual-trigger	Contact closure relay is triggered
manual-off	Contact closure relay is not triggered

read-write

general

To specify that contact closure for relay 2 of port 1 on module 10 is controlled by the call controller:

Gxxx-001(super)# set contact-closure admin 10/1:2 mgc

Send Feedback